Single Satellite Search - Pansat 9500HDX User Manual

3.2.2.1 Motor DiSEqC
DiSEqC 1.2
"Local Longitude"/"Local Latitude" is disabled for DiSEqC 1.2
Motor Setting

Select "Motor Setting" in the DiSEqC 1.2 menu

Press◀ ▶ buttons to change satellite or transponder

Go to "Position No. & Save"
Press ◀ ▶ buttons or numbers to select or input
o
Position NO.

"Go to X"
Press [OK] to open a list. You can go to X or go
o
to reference.

Select "Satellite"
Highlight "West/Save/East" and press the ◀ ▶
o
buttons to move the dish.
Press [OK] to save the position.
o

"Recalculation"
Selection
o
recalculate.
USALS

Set the satellite's longitude and local longitude / local latitude. USALS can move the dish automatically.

Local Longitude: Please input the Local Longitude using the numeric keys. Adjust East/West using the ◀ ▶
buttons

Local Latitude: Please input the Local Latitude using the numeric keys and adjust South/North using the ◀ ▶
buttons

Motor Setting: Switching the satellite can move the dish to the right place

Limit Setup: When you set "limit setup" to "West Limit/ East Limit", you can move the dish to the west or east by
pressing◀ ▶ buttons manually. When you are finished moving to the target place, please press [OK] key to
save the point.
3.2.2.2 Skew Control
If a LNB with a mechanical polarizer is used in your system, adjust the skew value by using the ◀ ▶ buttons while
monitoring the signal status bar. Adjust to the maximum signal status point.

3.2.3 Single Satellite Search


Select the satellite to scan

Scan Option: Scan All Channels or Scan Free Channels

Scan Channel: Scan TV+Radio Channels, TV Channels, or Radio Channels

Network Scan: Enable/Disable Network Scan

Scan Mode: Normal Scan or Blind Scan
this option and press
8
[OK] to