Jet J-7015 Operating Instructions And Parts Manual page 22

Troubleshooting
Fault
1. Blade speed too high for feed
Bad cuts (rough)
2. Blade is too coarse.
1. Blade is binding in the cut.
Blade is twisting
2. Blade tension too high
1. Blade guides worn
2. Blade guide bearings not adjusted.
Unusual wear on
side/back of blade
3. Blade guide bearing bracket is
Probable Cause
pressure.
loose.
1. Reduce blade speed and feed
pressure.
2. Replace with finer blade.
1. Decrease feed pressure.
2. Decrease tension on Blade
1. Replace blade guides.
2. Adjust blade guide bearings.
3. Tighten blade guide bearing bracket.
22
Suggested remedy