Selecting Preset Codes Directly; Controls; Programming Signals From Other Remote - Pioneer VSX-1020-K Operating Insructions

09 Controlling the rest of your system

Selecting preset codes directly

1 Press and hold R.SETUP, then press "1"
for three seconds.
The LED flashes continuously.
• To cancel the preset setup mode press
R.SETUP.
2 Press the input function button for the
component you want to control.
When assigning preset codes to TV CONTROL,
press TV CTRL here.
The LED blinks once and flashes continuously.
3 Use the number buttons to enter the 4-
digit preset code.
See Preset code list on page 123.
If the LED lights for one second, the setting has
been successfully completed.
When the preset code is fully input, the LED
flashes three times to indicate that the setting
has failed. If this happens, enter the 4-digit
preset code again.
4 Repeat steps 2 through 3 for the other
components you want to control.
To try out the remote control, switch the
component on or off (into standby) by pressing
 SOURCE. If it doesn't seem to work, select
the next code from the list (if there is one).
5 Press R.SETUP to exit the preset setup
mode.
Note
1 The remote can store about 120 preset codes from other components (this has been tested with codes of Pioneer
format only).
78
En
Programming signals from other
remote controls
If the preset code for your component is not
available, or the available preset codes do not
operate correctly, you can program signals
from the remote control of another component.
This can also be used to program additional
operations (buttons not covered in the presets)
after assigning a preset code.
Certain buttons represent operations that
cannot be learned from other remote controls.
The buttons available are shown below:
RECEIVER MULTI SOURCE
OPERATION
R.SETUP
BD DVD DVR/BDR HDMI
TV CD NET RADIO ADAPTER
iPod USB TUNER VIDEO TV CTRL
RECEIVER
INPUT SELECT ZONE 2
MASTER
INPUT VOLUME
TV CONTROL
CH VOL
MUTE
1 Press and hold R.SETUP, then press "2"
for three seconds.
The LED flashes continuously.
• To cancel the preset setup mode press
R.SETUP.
2 Press the input function button for the
component you want to control.
The LED blinks once and flashes continuously.
1
AUDIO VIDEO
PARAMETER PARAMETER
LIST TUNE TOOLS
TOP MENU T.EDIT
BAND GUIDE
ENTER
PRESET PRESET
PTY
SEARCH
RETURN
HOME
TUNE
MENU
iPod CTRL
PGM MENU
HDD DVD
PHASE CTRL STATUS
TV / DTV MPX PQLS
S.RETRIEVER MIDNIGHT AUDIO
1 2 3
SIGNAL SEL MCACC SLEEP INFO
4 5 6 DISP
CH LEVEL A.ATT DIMMER
7 8 9
CH
D.ACCESS CLASS
0
/ CLR ENTER
AUTO / ALC /
DIRECT STEREO STANDARD ADV SURR
LISTENING MODE