What To Do If; Remedying A Malfunction - Electrolux EW 1477 F User Manual

What to do if...

Remedying a malfunction

In the event of a malfunction, try to rectify the prob-
lem yourself with the aid of the instructions provided
here. If you request a visit from Customer Service to
remedy one of the malfunctions listed here, or to rec-
tify an error made when using the appliance, the
Customer Service engineer's visit will not be free of
charge, even during the warranty period.
• If you press a button and "
multi-display, the selected function is not able to
be combined with the programme that has been
set.
• If the error code E10, E 20 or E 40 is shown in the
multi-display, you may be able to remedy the
error yourself (see the following malfunction
chart). After remedying the error, press the
(START/PAUSE) button.
• With all other displayed faults (E plus number or
letter): switch appliance off and on again. Reset
the wash programme and press the START/
PAUSE button.
If the fault code is displayed again, please contact
the Customer Service department quoting the fault
code.
Problem
The washing machine does
not work.
The loading door cannot be
closed.
E40
The error code is flash-
ing in the multi-display. The
C
l (MAIN WASH),
(END)
U
and (START/PAUSE) indi-
cators are flashing.
E10
The error code is flash-
ing in the multi-display. The
o C
(RINSE HOLD), (END)
U
and (START/PAUSE) indi-
cators are flashing. Water is
not entering the appliance.
Err
" flashes in the
U
Possible cause
The power plug is not connected.
A domestic fuse has tripped.
The loading door is not closed prop-
erly.
U
The (START/PAUSE) was not
pressed for long enough.
The child safety device is engaged.
The loading door is not closed prop-
erly.
The tap is turned off.
The filter in the threaded inlet hose fit-
ting is clogged.
Tap is furred with limescale or faulty.
Remedy
Connect the plug to a power outlet.
Replace the fuse.
Close the loading door; the catch must
audibly latch.
U
Press and hold the (START/PAUSE)
button until the programme starts.
Disengage the child safety device (see
section "Child safety device").
Close the loading door properly; there
should be an audible click.
Restart the programme.
Turn on the tap. Restart the programme.
Switch off the appliance. Turn off the
tap. Disconnect the power plug.
Unscrew the hose from the tap, remove
the filter and clean it under running
water.
Check the tap and have it repaired if
necessary.
25