Preparing The Location Where The Washing Machine Is To Be Installed - Electrolux EW 1477 F User Manual

Electrolux washing machines
Hide thumbs Also See for EW 1477 F:
Table of Contents

Advertisement

A special key A and sealing caps B
3
(2 pieces) and C (1 piece) are included with
the washing machine.
3. Remove the D screw incl. pressure spring using
the special key A.
4. Cap the hole using the C sealing cap.
Important: Press the sealing cap in strongly
enough so that it clicks into the rear wall (protects
the appliance interior from sprayed water).
5. Unscrew two E screws using the special key A.
6. Unscrew four F screws using the special key A.
7. Remove the G transport bars.
8. Screw the four F screws in again.
9. Cap the two large holes using the B sealing caps.
Important: Press the sealing caps in strongly
enough so that they click into the rear wall (pro-
tects the appliance interior from sprayed water).
Preparing the location where the washing machine is to
be installed
• The surface on which the washing machine is to
be installed must be clean and dry and free from
floor polish residue and other greasy coatings so
that the appliance does not slip. Do not use lubri-
cants to assist you in sliding the appliance.
• Installing the appliance on deep pile carpeting or
floor coverings with a soft foam backing is not
recommended as the stability of the appliance
cannot be guaranteed as a result.
• If the surface on which the appliance is to be
installed is covered with small tiles, place com-
mercially available small rubber mats under the
stands.
• Never place wood, cardboard or similar materials
to compensate for small unevennesses in the
floor; always adjust the screw feet instead.
• If installing the washing machine right next to a
gas or coal cooker is unavoidable due to space
restrictions: Insert a heat-insulating plate (85 x 57
cm) between the range and the washing machine;
the side of the plate that is facing the range is to
be covered with aluminium foil.
• The washing machine must not be installed in a
room which is at risk of frosting up. Frost damage
may result.
• The water inlet and outlet hose must not be
kinked or crushed.
34

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents