Starting A Wash Programme; Wash Programme Progress - Electrolux EW 1477 F User Manual

Starting a wash programme

1. Check that the tap is turned on.
2. Start a wash programme: Press the
PAUSE) button. The wash programme will start,
or will start automatically following a countdown
by the delay timer.
The loading door is not shut properly if after
3
having pressed the
ton
– the E40 error code is flashing in the multi-
display,
– and the l (MAIN WASH) and
indicators are flashing.
In such an event, firmly press the loading
door shut and press the
button again.
if the delay timer has been set:
The time delay that has been set begins to count-
down and the time remaining until the programme is
due to start (always in complete hours) is indicated in
the multi-display. During this time you can add more
washing and change or cancel the delay timer.
• Adding washing:
U
Press the (START/PAUSE) button; the loading
door will be able to be opened. Then close the
door and press the
again.
• Changing or cancelling the delay timer:
U
Press the (START/PAUSE) button. Continue
X
pressing the (DELAY TIMER) button until the
desired time is shown; when showing the pro-
gramme length (display in hours and minutes, e.g.
2. 0 6) will start the wash programme without delay.

Wash programme progress

Programme progress display
Before the programme starts, the steps of the pro-
gramme which will be carried out are indicated in the
programme progress display. During the wash pro-
gramme the current stage of the programme is
shown.
Multi-display
The expected remaining programme time is shown
(in hours and minutes) in the multi-display until the
programme is completed.
The remaining
3
increase or remain constant during the wash
programme as the programme adjusts to
various conditions while washing (e. g. type
of washing, amount of washing, recognising
out-of-balance when spinning, special rinse
cycle etc.).
U
(START/
U
(START/PAUSE) but-
C
(END)
U
(START/PAUSE)
U
(START/PAUSE) button
programme time may
19