Table of Contents
Advertisement
Initial Installation
When you are installing an enclosure in a rack or tower you must observe the following
warning.
Use the procedures in the following sections to remove all the elements to make the
enclosure easier to handle. Once the enclosure is mounted you can replace the elements.
WARNING: An assembled enclosure (all elements installed) weighs more than 65 lb
(29.5 kg). Moving the assembled enclosure requires a minimum of two individuals.
To safely and easily install the enclosure requires removing the drives, power supply
and blowers, EMU, and I/O module. This reduces the enclosure weight to
approximately 24 lb (11.3 kg). Even though a single person can lift this weight, the
physical size makes it very difficult to install.
Compaq requires a minimum of two individual to install an empty enclosure in a rack
or tower.
The handles cannot support the weight of the enclosure. Only use these handles to
position the enclosure in the mounting brackets. DO NOT use the handles to lift the
enclosure.
Replacing CRUs
7–3
Advertisement
Table of Contents
