Operation - American Standard 2422L / V Installation And Operation Manual

OPERATION:

NOTE: Each whirlpool is shipped from the factory with an air actuator on/off switch and pump with attached
power supply cord. OPERATING THE SYSTEM WITHOUT WATER (DRY RUNNING) WILL CAUSE PUMP
DAMAGE AND VOID THE WARRANTY. Always fill the whirlpool before operating the pump. The air switch is
mounted either on the deck or side wall of the tub.
1.
Fill the Whirlpool: Water level must be at least one inch (25mm) above the highest jet for proper operation.
(See diagram below.)
Do not fill whirlpool more than 2/3 full prior to the user completely immersing themselves into unit.
2.
Start Whirlpool: Push on center of button. Button will depress and whirlpool will start.
3. Stop Whirlpool: Depress and release button and whirlpool will stop.
REMOVABLE BLANK
Air Volume Control Adjustments: Water turbulence is determined by the amount of air mixed with the
4.
water. Rotate the air volume control counterclockwise for more turbulence--clockwise for less.
753737-100 Rev. E
SAFE-T-HEATER
*
AIR TUBING
WATER LEVEL
* 6060L/V includes factory installed heater
Air Volume Control Adjustments:
MORE AIR
AIR ACTUATOR SWITCH
(location varies with model)
LESS AIR
14
OUTLET MUST BE
GFCI PROTECTED
(all heaters require separate GFCI)