Removing A Pc Card Or Blank - Dell Inspiron 6000 PP12L Owner's Manual

To install a PC Card:
1 Hold the card with the top side of the card facing up. The latch may need to be in the "in"
position before you insert the card.
2 Slide the card into the slot until the card is completely seated in its connector.
If you encounter too much resistance, do not force the card. Check the card orientation and
try again.
The computer recognizes most PC Cards and automatically loads the appropriate device driver. If
the configuration program tells you to load the manufacturer's drivers, use the floppy disk or CD
that came with the PC Card.

Removing a PC Card or Blank

NOTICE:
stop it from functioning before you remove it from the computer. If you do not stop the card in the
configuration utility, you could lose data. Do not attempt to eject a card by pulling its cable, if one is
attached.
CAUTION:
Product Information Guide.
Press the latch and remove the card or blank. For some latches, you must press the latch twice: once
to pop the latch out, and then a second time to pop the card out.
44
Using PC Cards
Use the PC Card configuration utility (click the
Before you begin any of the procedures in this section, follow the safety instructions in the
icon in the taskbar) to select a card and