Table of Contents
Advertisement
The computer recognizes most PC Cards and automatically loads the appropriate device driver. If the configuration program tells you to load the
manufacturer's drivers, use the floppy or CD that came with the PC Card.
Removing a PC Card or Blank
NOTICE:
Use the PC Card configuration utility (click the
the computer. If you do not stop the card in the configuration utility, you could lose data. Do not attempt to eject a card by pulling its cable, if one is
attached.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTE:
This computer uses digital sound, and contains no analog audio lines. PCMCIA cards such as modems that use analog lines to produce sound will
not function.
1. Press in on the end of the latch once or twice as applicable.
2. Remove the card or blank.
Save a blank to use when no PC Card is installed in a slot. Blanks protect unused slots from dust and other particles.
1
eject button
2
PC card
Back to Contents Page
icon in the taskbar) to select a card and stop it from functioning before you remove it from
- Quick Links:
- About Your Computer
Hide quick links:
Advertisement
Table of Contents
