Dell INSPIRON PP05XB Owner's Manual page 47

To enter standby mode:
• Click the Start button, click Turn off computer, and then click Stand by.
or
• Depending on how you set the power management options on the
Properties window, use one of the following methods:
– Press the power button.
– Close the display.
– Press <Fn><Esc>.
To exit standby mode, press the power button or open the display depending on how you set the options
on the Advanced tab. You cannot make the computer exit standby mode by pressing a key or touching
the touch pad.
Hibernate Mode
Hibernate mode conserves power by copying system data to a reserved area on the hard drive and then
completely turning off the computer. When the computer exits hibernate mode, it returns to the same
operating state it was in before entering hibernate mode.
NOTICE:
You should not remove devices while your computer is in hibernate mode.
Your computer enters hibernate mode if the battery charge level becomes critically low.
To manually enter hibernate mode:
• Click the Start button, click Turn off computer, press and hold <Shift>, and then click Hibernate.
or
• Depending on how you set the power management options on the
Properties window, use one of the following methods to enter hibernate mode:
– Press the power button.
– Close the display.
– Press <Fn><Esc>.
– Press <Fn><F1>.
NOTE:
Some ExpressCards may not operate correctly after the computer exits hibernate mode. You may need to
remove and reinsert the card (see "Removing an ExpressCard or Blank" on page 76), or simply restart (reboot) your
computer.
To exit hibernate mode, press the power button. The computer may take a short time to exit hibernate
mode. You cannot make the computer exit hibernate mode by pressing a key or touching the touch pad.
For more information on hibernate mode, see the documentation that came with your operating system.
Advanced tab in the Power Options
Advanced tab in the Power Options
Using a Battery
47