Mac And Compatibles Installation; Scanner Installation - Ricoh ImageReader FB User Manual

2400 dpi flatbed scanner with 30-bit super color

Table of Contents

Installing the device dr

Installing the de

vice dr

vice dri i i i i v v v v v er er er er er

Installing the de

vice dr

Run the Info Technician to install the scanner drivers. To do so:

1 . Insert disk 1 of the Info Technician into the computer's floppy drive.

2.In Windows Program Manager, select the Run command from he File menu. If you are

using Windows 95, select Run from the Start menu on the desktop.

3. Ty

at the command line and click OK. Substitute the

A:\SETUP

pe A:\SETUP

A:\SETUP

appropriate drive letter if the disk is not in the A drive.

4. Follow the on screen directions.

The scanner's device driver is installed in the proper directory, along with the TWAIN driver.

5. Reboot the computer after the installation is complete to activate

the scanner drivers.

Mac and compatibles installation

The ImageReader FB is capable of running on a Macintosh or Mac compatibles as well as

PCs. If this unit shipped with Mac software and a plug-in driver (not all models do), read

this section for instructions about installing this scanner on your Mac system.

Set the scanner to a unique SCSI ID. Attach the 50-pin SCSI terminator block to the port on

the scanner, and connect the SCSI cable to the terminator block. Pace the scanner unit In the

desired location, and route the interface cable to the computer in such a way as to assure it is

safe from possible damage due to pinching or crimping. Insert the 25-pin male connector on

the cable into the SCSI port on your Mac, or the last device on your chain. The cable can

only be inserted one way - do not force a connection. Connect the power cable as well.

Once the scanner is attached and near the location you want it, unlock the scanning mecha-

nism. The scanner is locked for transport to avoid damage to the assembly. You must unlock

the scanner

Table of Contents