Connecting The Scanner; The Info Technician - Ricoh ImageReader FB User Manual

4. Use the slot cover's screw to retain the interface card. Replace the housing and secure all screws.
5. Reconne t the power source to your computer and any other peripheral equipment.,

Connecting the scanner

Connecting the scanner Connecting the scanner Connecting the scanner Connecting the scanner
If you have other SCSI devices installed on your system, set the scanner to a unique SCSI ID. Attach the 50-pin SCSI
terminator block to the port on the scanner, and connect the SCSI cable to the terminator block. Place the scanner unit
in the desired location, and route the interface cable to the computer in such a way as to assure it is safe from possible
damage due to pinching or crimping. Insert the 25-pin male connector on the cable into the port on the interface card.
The cable can only be inserted one way - do not force a connection. Connect the power cable as well.
Once the scanner is attached and near the location you want it, unlock the scanning mechanism. The scanner is looked
for transport to avoid damage to the assembly. You must unlock the scanner before you turn it on for the first time.
Failure to do so may cause damage to the scanner, and will void your warranty. Simply turn the dial on the bottom of
the scanner to the unlock position.
T T T T T he Inf he Info o o o o T T T T T ec ec ec ec echnician he Inf he Inf hnician hnician hnician
he Inf hnician
The Info Technician is an automatic installation utility that edits and installs the scanner's device and TWAIN drivers.
These drivers provide the link between the scanning hardware, the scanning application, and the computer's operating
system.
2-2