Set Mode - Icom IC-M35 Instruction Manual

7

SET MODE

D Power save function
The power save function reduces current drain by deactivat-
ing the receiver circuit for preset intervals.
• OFF : The power save function is turned OFF.
• ON : The power save function is turned ON. The power save
function will be activated when no signal is received, and no
operation is performed for 5 sec.
Power save ON
(default)
D Squelch sensitivity
When this function is turned ON, rejection of noise is im-
proved so that the audio is not easily affected by noise.
Squelch sensitivity
OFF (default)
20
"PS"
Push
Power save OFF
"SS"
Push
Squelch sensitivity
ON
D Low fi x function
( Appears only when the optional battery case is attached; not
available with German version depending on the pre-setting.)
When this function is turned ON, the output power is fi xed to
low except for Channel 16.
Push
Low fix function
OFF (default)
D Noise detection function "nd"
The noise detection function enables the transceiver to de-
tect the ambient noise while in the standby condition. If the
detecting noise and the received signal are stronger than the
specifi c level, the transceiver increases the volume level au-
tomatically to suit the environment when receiving a signal.
When the squelch is open, the transceiver won't detect noise.
• OFF : The noise detection function is turned OFF.
• Low : When the detecting noise is louder than the specific level,
the transceiver turns up the volume.
• High : When the detecting noise is louder than the specifi c level, the
transceiver turns up the volume greater than "Low" setting.
Push
Noise detection function
OFF (default)
"LF"
Low fix function ON
Noise detection function
ON (High)