Table of Contents
Advertisement
DSL-G624M Wireless 108G MIMO ADSL2/2+ Router User's Guide
Information you will need about your DSL-G624M ADSL Router:
Username
Password
LAN IP addresses for
the DSL-G624M
LAN Subnet Mask for
the DSL-G624M
Information you will need about your LAN or computer:
Ethernet NIC
DHCP Client status
It is recommended that your collect and record this information here, or in some other secure place, in case you have to
re-configure your ADSL connection in the future.
Once you have the above information, you are ready to setup and configure your DSL-G624M ADSL Router.
This is the Username needed access the Router's
management interface. When you attempt to connect to
the device through a web browser you will be prompted
to enter this Username. The default Username for the
Router is admin. The user cannot change this.
This is the Password you will be prompted to enter
when you access the Router's management interface.
The default Password is admin. The user may change
this.
This is the IP address you will enter into the Address
field of your web browser to access the Router's
configuration graphical user interface (GUI) using a
web browser. The default IP address is 192.168.1.1.
This may be changed to suit any IP address scheme
the user desires. This address will be the base IP
address used for DHCP service on the LAN when
DHCP is enabled.
This is the subnet mask used by the DSL-G624M, and
will be used throughout your LAN. The default subnet
mask is 255.255.255.0. This can be changed later.
If your computer has an Ethernet NIC, you can
connect the DSL-G624M to this Ethernet port using
an Ethernet cable. You can also use the Ethernet
ports on the DSL-G624M to connect to other
computer or Ethernet devices.
Your DSL-G624M ADSL Router is configured, by
default, to be a DHCP server. This means that it can
assign an IP address, subnet mask, and a default
gateway address to computers on your LAN. The
default range of IP addresses the DSL-G624M will
assign are from 192.168.1.2 to 192.168.1.33. Your
computer (or computers) needs to be configured to
Obtain an IP address automatically (that is, they
need to be configured as DHCP clients.)
vii
Record info here
Record info here
Advertisement
Table of Contents
