HUSKY LINERS 3231 Care And Use Instructions

Husky floor liner

THANK YOU FOR SELECTING A HUSKY FLOOR LINER

Your new floor liners are custom molded to fit your particular vehicle. The liners are made to take the place

of your factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your

new floor liners. However, do not remove the factory-installed carpeting.

Your liners are made from an engineering resin that is lightweight and extremely tough and durable. The

easiest way to clean your liners is with a damp cloth or sponge. If using a cleaner, 409

well. Use of Armor All

INSTALLATION INSTRUCTIONS FOR YOUR S-10/BLAZER/

BRAVADA/ENVOY/HOMBRE/JIMMY/SONOMA FLOOR LINERS

LEFT OR

DRIVER'S

SIDE

SEE BACK OF THIS SHEET FOR ADDITIONAL INSTRUCTIONS.

FROM WINFIELD CONSUMER PRODUCTS

CARE AND USE INSTRUCTIONS

, Son-of-a-Gun

or similar items is discouraged as these products make the liners slick.

or Glass Plus

RIGHT OR

PASSENGER'S

SIDE

3231 Front_Rear.doc

work

09/18/03

Table of Contents

Need help?

Do you have a question about the 3231 and is the answer not in the manual?

Page 1 , Son-of-a-Gun or similar items is discouraged as these products make the liners slick. INSTALLATION INSTRUCTIONS FOR YOUR S-10/BLAZER/ BRAVADA/ENVOY/HOMBRE/JIMMY/SONOMA FLOOR LINERS LEFT OR RIGHT OR DRIVER’S PASSENGER’S SIDE SIDE SEE BACK OF THIS SHEET FOR ADDITIONAL INSTRUCTIONS. 3231 Front_Rear.doc 09/18/03...
Page 2 PHOTO 1. ARROW POINTING TO PHOTO 2. VELCRO® HOOK PAD NIB THAT HAS BEEN REMOVED SHOWN ATTACHED TO LINER. TO ALLOW HOOK PAD TO LAY FLAY. PHOTO 3. ANCHOR SCREW SHOWN INSTALLED IN CARPET ALIGNED BELOW HOOK PAD. 3231 Front_Rear.doc 09/18/03...