HUSKY LINERS 6368 Care And Use Instructions

THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of your
factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your new floor
liner. However, do not remove the factory-installed carpeting.
Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The easiest way
® ®
to clean your liner is with a damp cloth or sponge. If using a cleaner, 409 or Glass Plus work well. Use of Armor
® ®
All , Son-of-a-Gun or similar items is discouraged as these products make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR FORD F-150
SUPER CREW TRUCK SECOND SEAT FLOOR LINER
AREA 1
LEFT OR RIGHT OR
PASSENGER'S
DRIVER'S
SIDE SIDE
AREA 2
ON VEHICLES EQUIPPED WITHOUT A FACTORY CENTER CONSOLE, IT WILL BE NECESSARY TO TRIM AWAY
A PORTION OF THE LINER. TRIM BY REMOVING THE RECESSED AREA OF THE LINER ALONG THE FRONT
EDGE AS SHOWN ABOVE (SEE AREA 1). A UTILITY KNIFE OR SCISSORS WORK WELL FOR TRIMMING. USE
OFFSET "STEP" AS TRIMMING GUIDE. SEE BACK OF PAGE FOR TRIMMING PHOTOS.
ON VEHICLES EQUIPPED WITH A FACTORY SUBWOOFER (UNDER DRIVER'S SIDE REAR SEAT), TRIM LINER
AS SHOWN ABOVE (AREA 2). USE THE RAISED GROOVE AS A TRIM GUIDE, TRIMMING ALONG THE BACK
EDGE (LEAVING RAISED AREA). CONTINUE TRIM OVER HUMP FOLLOWING OFFSET STEP IN PART AS A
GUIDE. TRIMMING PHOTOS ARE INCLUDED ON BACK OF THIS PAGE.
6368 Front_Back.doc
01/22/2004