Table of Contents
Advertisement
GB-5751010800
26-01-2004
Turning on and setting the timer
ELECTRICAL CONNECTION
Before plugging in check that:
• the mains supply corresponds to the
power supply shown on the rating plate;
• the socket and the mains lead correspond
to the power requirements of the applian-
ce;
• the socket is suited to the plug, otherwise
have the socket replaced;
• the socket is properly grounded.
The manufactures cannot be held responsi-
ble for any damages due to failure in fol-
lowing normal safety procedures.
Replacement of the power cable must be
carried out by qualified personnel.
USE OF THE TIMER
Before setting the required function, check
that the switch on the timer
ON.
If you wish to use the timer, position the switch
in the intermediate position
12
9
6
When the timer's on the OFF position, the
appliance doesn't work.
16:27
Pagina 21
is in position
15
.
ON
1
0
OFF
SETTING THE TIMER
The programmer/timer
must be set to the exact time. If for example
it is 4.00 pm. (16.00), turn the dial in a clockwi-
se direction (following the direction of the
arrow) until the number 16 is lined up with the
triangular pointer (the arrows indicates 4:00
P.M. approximately ).
20
N.B.: Never turn the dial in an anti-clockwise
direction!
The timer is in effect, an electric clock and
works only if the plug is connected to the
power supply. Whenever the plug is discon-
nected or there is a power failure, the pro-
grammer stops (the clock is then "slow") and
must be re-set.
PROGRAMMED MODE
1) Set the operating times by pushing out the
notches on the dial corresponding to the
period required (each notch represents 15
mins.)
2) Make sure that the timer indicates the cor-
rect time (see instructions on setting).
3) Select the desired function as shown in the
chart overleaf.
operating time
Funzionamento
Once programmed in this way, the applian-
ce will repeat the pre-established program
every day, if the selector is in the
16
, like all clocks,
pointer
position.
21
Advertisement
Table of Contents
