Table of Contents
Advertisement
5.2.9.2 Firmware Download & Upload
FIGURE 19: Upload System Firmware
From time to time Newmar may issue new firmware for the SPM-200. This will usually come as a "zip" file.
Download the zip file from www.newmartelecom.com/site_power_monitor/site_power_monitor.html to your
computer and "unzip" it. Then navigate to this section of the Config page, and click the "Browse" button.
Navigate to the directory that you unzipped the package into, and double click on the file with the ".PKG
extension".
Click the "Upload New Firmware" button, and wait. The upload process may take a few minutes, depending
on the size of the update file and network traffic. (Note that due to the various differences between browsers,
you may or may not see an in-progress report as each block of data is uploaded.) During this time, both the
IDLE and ACTIVITY LEDs should blink in unison on the SPM-200.
Once the download is complete, an "Upload Succeeded" message will be displayed, with a 60 second
countdown while the unit validates and installs the new software. Once it has completed, it will reboot the
SPM-200. Once it has rebooted it will again display the "Sensors" page.
Should you run into any trouble while updating, please DO NOT reset your SPM and contact us at:
Phone: 800-354-3906 • Email: techservice@newmarpower.com
This next page is fairly self-explanatory:
5.2.9.3 Test SNMP Trap & Email
FIGURE 20: Test Buttons
Clicking on these buttons allows you to test if you have set up your email and SNMP traps properly.
The final section sets up the information that is gathered through Syslog.
P.O. Box 1306
Newport Beach
California 92663
Phone: 714-751-0488
Fax: 714-957-1621
E-Mail: techservice@newmarpower.com
23
Hide quick links:
Advertisement
Table of Contents
