Table of Contents
Advertisement
If you have a DHCP server, check the box indicated. Otherwise, enter the appropriate IP address, Subnet Mask
and Gateway address. CAUTION: once you click "Save Changes", the SPM will IMMEDIATELY switch to the
IP address you just entered, or attempt to obtain an IP address from a DHCP server. It will NOT respond at
192.168.123.123 anymore. Also note that if you select "DHCP" and there is no DHCP server available, you will
not be able to access the SPM-200 again at all. See 9.0 Appendix B: Troubleshooting #14 which describes the
"Reset" button in order to recover.
If you are sure you have the correct settings, go ahead and click the "Save Changes" button. Now you will
have to disconnect the SPM from the PC and the crossover cable, and connect it to your real network. You
should be able to access it by opening a browser window and entering the new address that you just set.
5.0 SPM-200 Web Page Overview
The Sensors web page is the home page for the SPM-200. It is the page that will be displayed when you first
connect to an SPM. The Sensors Page shows the current value of all the inputs to the SPM. A Sensors Page from
an SPM that has been running a while is shown on the following page, see FIGURE 8:
FIGURE 8: SPM-200 Homepage (Configured Unit)
P.O. Box 1306
Newport Beach
California 92663
Phone: 714-751-0488
Fax: 714-957-1621
E-Mail: techservice@newmarpower.com
14
Hide quick links:
Advertisement
Table of Contents
