Table of Contents
Advertisement
Syslog is a utility that runs on a UNIX machine to capture error messages from systems like the SPM-200.
Newmar Support may ask you to configure this utility to help debug a problem with the SPM-200 software. It
does not perform any function in the normal operation of the SPM-200.
Scroll down further to the Email Configuration Section.
5.2.7 Configuring Email Setting
FIGURE 15: Email Settings
The SPM-200 can be configured to send emails when alarms are raised. Emails can be sent to any
combination of five addresses. Refer back to FIGURE 7 – there we determined which alarms will cause emails
to go to which of the five addresses. Here is where we set those addresses.
The SPM-200 uses the standard SMTP/POP3 email services. Contact Newmar support for information on using
other email systems such as Gmail or AOL. Contact your system administrator or ISP for the SMTP and POP3
addresses for your system. The emails that are sent will have the return address that is entered in the "From"
Email Address field, and they will contain information about which alarm has been tripped and why.
Again, the figure above is for illustration purposes only. It doesn't make much sense to have the "From" and
"To" addresses be the same, but there's no reason you can't set it that way.
Again, don't forget to click the "Save Changes" button.
5.2.7.1 Sending Text Messages
The SPM can send text messages by sending emails to a special address at the cell phone provider. Below is a
list of addresses for some popular providers. For example, if you have cell service with AT& T, you can send a
test message by sending an email to xxxxxxxxx@txt.att.net, where xxxxxxxxxx is your cell phone number.
P.O. Box 1306
Newport Beach
California 92663
Phone: 714-751-0488
Fax: 714-957-1621
E-Mail: techservice@newmarpower.com
20
Hide quick links:
Advertisement
Table of Contents
