Table of Contents
Advertisement
causes the displayed value of the current to be wrong. Clicking the "Zero Current Channel" button zeros out
this error. CAUTION: be sure that there is no current flowing through the shunt before clicking this button. If
there is some current flowing then clicking the button will introduce a constant error into the current reading.
5.2.4 Web Server
Scroll down the Config page past the Clock and Network Settings sections until you see this:
FIGURE 13: Setting up the Web Server and Configuring DNS
The "Web Server" section controls the SPM-200's built in Web Server. You can select the HTTP protocol, the
secure HTTPS protocol, or both. The port numbers shown are the defaults for HTTP and HTTPS. You can change
these numbers, but it's usually best to leave them at the default values.
5.2.5 DNS Servers
The "DNS" or "Domain Name Servers" section lists the addresses of the Internet servers that the SPM-200
will call to resolve Web names like "mail.xyzco.com" to their actual IP addresses. The values shown are for
demonstration purposes only – consult your system administrator or Internet Provider to get the values for your
network.
Password Configuration was previously mentioned in "Setting Account Names and Passwords" in Setup
Section
Skip down to the Syslog Section:
5.2.6 Syslog Settings
FIGURE 14: Syslog Settings
P.O. Box 1306
Newport Beach
California 92663
Phone: 714-751-0488
Fax: 714-957-1621
E-Mail: techservice@newmarpower.com
19
Hide quick links:
Advertisement
Table of Contents
