Table of Contents
Advertisement
2.2.3 Temperature Sensor
This sensor is located on the top right hand side corner of the SPM-200 when vertically mounted and senses
ambient temperature. A protective guard prevents damage to the exposed sensor.
Sensor Range: -20° C to +60° C/-20° F to +140° F
Accuracy: +/- .5%
See section 5.1
SPM-200 Web page overview pages 17 and 18 for more information on setting Temperature
unit
(°C or °F) and Internal Temperature offset.
2.3 System Requirements
To enable the full remote access feature requires:
• Ethernet connectivity via RJ-45 plug, 10 BaseT
• Static IP address (see Appendix A for non-static IP address option)
• SNMP manager software. SPM-200 supports V1 & V2c
2.4 Materials Provided
The following items are provided with the SPM-200:
Qty (1) Screwdriver (00 Philips)
(1) Installation/Operation Manual (CD-ROM) and short form.
(4) 1 Amp In-Line Fuse Assembly, P/N: 563-0498-0
(4) ACG-1 Fuse, P/N: 554-0100-0
(1) 100A/100mV shunt, P/N: 575-2000-0
(4) # 8 Sheet Metal, SS, Pan Head Screws, 1". Phillips, P/N: 730-0816-2 (Mount SPM and Shunt)
(2) DIN-rail (35mm) End Clamps, P/N: 701-0040-0
(1) CAT .5 Cross-Over Cable, P/N: 873-0048-0 (use with laptop or PC for set-up)
2.5 Optional Accessories
The following materials are optional (not provided) and are available through NEWMAR. Please reference
part number when ordering.
• Rack Mounting Kit, model: RM-SPM – 19 or 23", P/N: 020-5091-0
• 48 VDC to 12 VDC Isolated DC Converter, model: 48-12-1i
• Sensors
• Water
• Door/Window Open alarm
• Fire/Smoke Detector
• Software
• Multi site monitor software – Model: 100 SS –Site Software - SPM
3.0 Installation
3.1 Mechanical
There are 3 methods of mounting: Wall, DIN-rail, and Rack. Regardless of method, please observe the
following: free air flow (away from other equipments' hot air exhaust so that the temperature sensor reads
accurately). Indoor installation only! No exposure to rain, spray, or moisture. Plan your wire routing when
considering location.
Option A: Wall, Panel, or Inside Enclosure Mounting
The SPM can be mounted on any flat secure surface (wall or tray) using screws through the four holes on the
mounting tabs (#8 screws recommended). Orientation should provide access to the front panel terminal block.
Option B: DIN-rail Mounting
The chassis supports DIN mounting via a 35mm rail at least 8 inches long. Installer needs to provide DIN-rail.
Two DIN-rail end clamps, P/N: 701-0040-0 provided.
P.O. Box 1306
Newport Beach
California 92663
Phone: 714-751-0488
Fax: 714-957-1621
E-Mail: techservice@newmarpower.com
3
Hide quick links:
Advertisement
Table of Contents
