Cisco Nexus 3000 Series Installation Manual page 64

Grounding the Switch
S e n d d o c u m e n t c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
To attach the ESD wrist strap to the system ground lug screw for any of the Cisco Nexus 3000 Series
switches, clip the grounding wire to the screw that attaches the grounding lug to the switch chassis (see
Figure
Figure 2-7
1
ESD ground strap
2 Clip attached to grounding lug
3 Side view of grounding lug (clip slid behind
screw)
In addition, follow these guidelines when handling modules:
• Handle carriers by available handles or edges only; avoid touching the printed circuit boards or
connectors.
Place a removed component board-side-up on an antistatic surface or in a static-shielding container.
•
If you plan to return the component to the factory, immediately place it in a static-shielding
container.
Never attempt to remove the printed circuit board from the metal carrier.
•
Cisco Nexus 3000 Series Hardware Installation Guide
2-16
2-7).
Attaching the ESD Wrist Strap to the System Ground Lug Screw
Chapter 2 Installing the Cisco Nexus 3000 Series Switches
1
4
Clip installed (behind screw)
5 System ground connector
5
2
3
4
OL-25338-04