Installing A Fan Tray - Cisco Nexus 3000 Series Installation Manual

Replacing a Fan Tray
S e n d d o c u m e n t c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
If you are replacing a fan tray during operations, you must insert the new fan tray within 2 minutes of
Caution
removing the original fan tray.

Installing a Fan Tray

Caution If you are replacing a fan tray during operations, you must insert the new fan tray within 2 minutes of
removing the original fan tray.
To install a fan tray, follow these steps:
Hold the fan tray with the sheet metal flange holding the connector on the bottom.
Step 1
Place the fan tray into the front chassis cavity so it rests on the chassis, and then push the fan tray into
Step 2
the chassis as far as it can go until the captive screw makes contact with the chassis.
Tighten the captive screw.
Step 3
Listen for the fans if the device is powered on. You should immediately hear them operating. If you do
Step 4
not hear them, ensure that the fan tray is inserted completely in the chassis and the faceplate is flush with
the outside surface of the chassis.
Step 5 Verify that the LED is green. If the LED is not green, one or more fans are faulty. If this problem occurs,
contact your customer service representative for a replacement part.
If you purchased this product through a Cisco reseller, contact the reseller directly for technical support.
Note
If you purchased this product directly from Cisco, contact Cisco Technical Support at this URL:
http://www.cisco.com/en/US/support/tsd_cisco_worldwide_contacts.html.
Cisco Nexus 3000 Series Hardware Installation Guide
4-6
Chapter 4 Replacing Components
OL-25338-04