Husqvarna

1130ST Owner's Manual page 9

SPARK
PLUG
SAFETY
IGNITION
KEY
CHOKE
CON-
TROL
THROTTLE /
ENGINE
CONTROL
RECOIL
POWER
(AUXILIARY)
CORD
STARTER
PLUG
HANDLE
PRIMER
NOTE: ITEMS
ABOVE ARE
SHOWN IN THEIR
TYPICAL LOCATION
ON THE ENGINE.
ACTUAL LOCATION
MAY VARY WITH
THE ENGINE ON
YOUR UNIT.
AUGER
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts, wrench.
Safety ignition key - must be inserted for the engine to
start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil (auxiliary) starter handle - used for starting the
engine.
Primer - pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
Choke Control - used for starting a cold engine.
Throttle/engine control - used to select either FAST or
SLOW engine speed and to STOP the engine.
LH and RH turn triggers - used to steer the snow thrower.
OPERATION
ENGINE OIL CAP
WITH DIPSTICK
OIL DRAIN
ELECTRIC
START
FUEL SHUT-OFF VALVE
BUTTON
DISCHARGE
CHUTE
AUGER
CONTROL
LEVER
DRIVE SPEED
CONTROL LEVER
GASOLINE
FILLER
CAP
CHUTE
DEFLECTOR
PLUG
Drive speed control lever - used to select forward or
reverse motion and speed of snow thrower.
Traction drive control lever - used to engage power-
propelled forward or reverse motion of snow thrower.
Auger control lever - used to engage auger motion (throw
snow).
Discharge chute control lever - used to change the
direction the snow is thrown.
Deflector remote control lever - used to change the
distance the snow is thrown.
Skid plate - used to adjust height of scraper bar from the
ground.
Drift cutter - used to cut through deep snowdrifts.
9
DISCHARGE CHUTE CONTROL LEVER
DEFLECTOR REMOTE
CONTROL LEVER
TRACTION
DRIVE
CONTROL
LEVER
LH TURN
TRIGGER
LIGHT
HANDLE
KNOB
MUFFLER
TOOLBOX
DRIFT CUTTER
SKID PLATE