Husqvarna

1130ST Owner's Manual page 6

TRACTION DRIVE
CONTROL LEVER
DRIVE
CONTROL
BRACKET
INSTALL AUGER CONTROL ROD
The auger control rod has the short loop on the end of the
spring as shown.
1. Slide rubber sleeve up rod and hook end of spring into
control arm with loop opening up as shown.
2. With top end of rod positioned under right side of control
panel, push down on rod and insert end of rod into hole
in auger control bracket. Secure with retainer spring.
AUGER
CONTROL
ROD
RUBBER
SLEEVE
CONTROL
ARM
ASSEMBLY
RETAINER
SPRING
TRACTION
DRIVE
CONTROL
ROD
LOOP
OPENING
UP
AUGER
CONTROL
ROD
INSTALL DISCHARGE CHUTE / CHUTE ROTATER HEAD
NOTE: The multi-wrench provided in your parts bag may be
used to install the chute rotater head.
1. Place discharge chute assembly on top of chute base
with discharge opening toward front of snow thrower.
2. Position chute rotater head over chute bracket. If
necessary, rotate chute assembly to align square and
pin on underside of chute rotater head with holes in
chute bracket.
3. With chute rotater head and chute bracket aligned,
position chute rotater head on pin and threaded stud of
mounting bracket.
4. Install 3/8 washer and locknut on threaded stud and
tighten securely.
CHUTE
ROTATER
HEAD
CHUTE
BRACKET
6
AUGER
CONTROL
RETAINER
LEVER
SPRING
AUGER
CONTROL
BRACKET
3/8 LOCKNUT
3/8 WASHER
THREADED
ROTATER HEAD
MOUNTING
BRACKET
PIN
STUD