Changing The Opening Direction Of The Door; (Freezer Compartment); Electrical Connection; Technical Specification - Electrolux ER 6730 U Installation And Instruction Manual

Changing the opening direction of
the door (freezer compartment)
(Only for model ER 6430 U)
Having changed the opening direction of the
appliance door, it is advisable to also change the
opening direction of the freezer compartment door.
To do this, proceed as follows:
Unscrew the two fixing screws to remove the lower
hinge from the door (Fig. 15).
Remove the freezer compartment door and the upper
hinge. Once the freezer door has been removed,
remove the screws from the catch and refit it on the
opposite side (Fig. 16).
Refit the upper hinge and the door on the opposite
side, then refit the lower hinge (Fig. 17).
When changing the opening direction of the door,
make sure that the hinges fit properly against the
surface on which the door seal rests.

Electrical connection

Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply.
Voltage can vary by 6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.
The technical data is indicated in the rating plate on the left side inside the appliance.
TECHNICAL SPECIFICATION
D576
D577
D578
Fig. 15
Fig. 16
Fig. 17
GB
23