Changing The Opening Direction Of The Door; Inner Door Reversal - Electrolux ER 1530 T Instruction Booklet

Changing the opening direction of the
door
Unplug the freezer before performing the following
operations:
Remove the ventilation grid (C-Fig. 2).
Unscrew the bottom hinge (D-Fig. 2).
Remove the door from the upper pivot (A-Fig. 3).
Remove the pivot from the upper hinge (B), then
mount it on the opposite side.
Re-assemble the door.
Screw down the bottom hinge (D-Fig. 2) on the oppo-
site side by using the screws previously removed.
Detach the plug (E-Fig. 2) from the ventilation grid (C).
To do this, press it in the direction of the arrow.
Introduce the plug into the hole left free on the oppo-
site side.
Re-assemble the ventilation grid.
Take off the handle cover (see Fig. 4), reverse the di-
rection of the handle.
The unused opening direction is concealed by plastic
plugs. Therefore, these plugs are to be mounted on
the holes left free.
Attention
After completion of the door reversibility operation,
verify that the door gasket is adherent to the cabinet.
If the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that
case, wait for the natural fitting of the gasket or accel-
erate this process by heating up the part involved with
a normal hairdrier.

Inner door reversal

(Only for model ER 1430 T)
Using a screwdriver release bracket (1) by pressing on
the internal spring (Fig. 5) and withdraw it from its seat
together with the door;
remove plug (2) and fit it in the hole left open on the
opposite side;
turn the door through 180 , remove the bracket (1)
and refit it on the opposite side.
Refit the door and insert the top pin and bottom
bracket (1), pushing it into place.
To ensure correct storage of food, the door is fitted
with a simple spring device which holds it in the open
position until it is properly closed.
D
E
C
E
D229
D230
B0646
180°
2
PR140
Fig. 2
E
Fig. 3
B
A
Fig. 4
Fig. 5
1
37