What To Do If; Error Messages Are Displayed - Electrolux ESL 6225 User Instructions

What to do if ...

Try to rectify minor faults on the dishwasher with the
aid of the instructions given here. If you call in cus-
tomer service to resolve one of the malfunctions
listed here, or rectify an error made in the operation

...Error messages are displayed.

If your appliance is equipped with an optical floor sig-
nal, in the event of an error a dot-shaped optical sig-
nal will flash on the floor.
Errors will only be indicated acoustically if
3
the acoustic signal has been activated.
If, as listed in the table below, any of the indi-
cators in the control panel or the display
panel are flashing or are illuminated, and/or if
an acoustic signal can be heard, you can
probably rectify the fault yourself.
Malfunction
One short continuously
repeated warning tone
can be heard; the cycle
indicator for the selected
dishwashing cycle is flash-
ing, the end cycle indicator
is flashing once repea-
tedly:
There is no water running
into the dishwasher.
Two short continously
repeated warning tones
can be heard; the cycle
indicator for the selected
dishwashing cycle is flash-
ing, the end cycle indicator
is flashing twice repeat-
edly:
Three short continuously
repeated warning tones
can be heard, the end cycle
indicator is flashing three
times repeatedly.
After rectifying the fault related to the 1 acoustic sig-
nal or the two acoustic signals press the button for
the commenced dishwashing cycle. The dishwashing
cycle will continue.
If the fault is displayed again, please contact Service
Force.
Possible cause
The tap is blocked or furred with lime-
scale.
The tap is turned off.
The filter (where present) in the threaded
hose fitting at the water inlet valve is
blocked.
Filters in the base of the washing com-
partment are blocked.
The water inlet hose has not been cor-
rectly laid.
The siphon is blocked.
The water drain hose has not been cor-
rectly laid.
The leak prevention system has been trig-
gered.
of the appliance, the customer service engineer's visit
is not free of charge, even during the period of guar-
antee.
Clean tap.
Turn the tap on.
Clean the filter in the threaded hose
fitting.
Cancel the dishwashing cycle (see
chapter: Starting a dishwashing
cycle), clean filters (see chapter:
Cleaning the filters), then start the
dishwashing cycle again.
Check hose installation.
Clean out siphon.
Check hose installation.
Turn off the tap and contact Service
Force.
For all other errors displayed, please contact
3
Service Force stating the error code (see
chapter: Service and Spare Parts).
Remedy
27