Starting A Dishwashing Cycle; Changing/Interrupting/Cancelling A Dishwashing Cycle; Load Sensing - Electrolux ESL 6225 User Instructions

Starting a dishwashing cycle

1. Check that the dishes and cutlery are stacked in
the dishwasher in such a way that the spray arms
are free to rotate.
2. Turn on the tap fully.
3. Press the ON/OFF button.
The LED indicators for all programme buttons
(and the button for the delay start timer if present)
light up. The LED indicators and any option but-
tons that are present only light up if they are acti-
vated.
4. Press the relevant button for the cycle required
(see "Programme Table").
The cycle display will become illuminated.
5. Close the dishwasher door. The dishwashing
cycle will begin.
If an acoustic error message can be heard
3
after the cycle has begun, please read the
section "What to do if ...".
Changing/interrupting/cancelling a
dishwashing cycle
Only change or interrupt a dishwashing cycle
3
that is in progress if it is absolutely neces-
sary. After the appliance has been closed
again, the air that has entered will be heated
significantly and expand. As a result, water
may collect in the base of the appliance and
trigger the anti-flood system.
Changing a dishwashing cycle
3 If you would like to change the dishwashing
cycle before closing the dishwasher door,
briefly press the button for the new dish-
washing cycle.
If you would like to change the dishwashing cycle
after the cycle has commenced, proceed as follows:
1 Hot steam may escape when the dishwasher
door is opened. There is a risk of scalding.
Be careful when opening the door of the
dishwasher.
1. Open the door of the dishwasher. The dishwash-
ing cycle will stop.
2. Press the button for the new dishwashing cycle
and hold it down.
First, the indicator for the dishwashing cycle that is
currently running will flash.
After several seconds only the indicator for the
new dishwashing cycle will be flashing.
3. Release the cycle button.
4. Close the dishwasher door. The newly selected
dishwashing cycle will commence from the begin-
ning.
Interrupting the dishwashing cycle by
opening the dishwasher door
1. Open the door of the dishwasher. The dishwash-
ing cycle will stop.
2. Close the dishwasher door. The dishwashing
cycle will continue.
Cancelling the dishwashing cycle
1. Open the door of the dishwasher.
2. Press function buttons 2 and 3 simultaneously for
approx. 2 seconds.
The LED indicators of all the programme buttons
that can be selected light up.
3. Release the function buttons.
The wash programme has been cancelled.
Turning off the dishwasher will only interrupt
3
a selected wash programme, not cancel it.
The wash programme will recommence after
turning the dishwasher back on again.

Load Sensing

If a wash programme is started even though there are
only a few dishes in the upper and/or lower basket, an
intelligent electronic system adjusts the amount of
water and the duration of the wash programme to the
number of dishes. By this means it is possible to
wash only a few dishes quickly and economically. At
half load (6 place settings), up to 2 litres of water and
0.2 kWh of electricity are saved.
23