Table of Contents
Advertisement
blade clearance
adjustment
in this procedure you will adjust the side support
to be parallel with the saw blade and
from it, then set the safety stop set screw (see
figure 16 )so that the side support cannot come
into contact with the blade when adjusting for dif-
ferent cuts.
Make sure the side support safety stop is
adjusted correctly so that the support can-
not come in contact with the blade when the
jig is properly mounted in the left-hand table
miter slot before using the jig. The jig side
support must stay at least
the blade at all times during operation. If the
side support and blade make contact, seri-
ous personal injury could result. at best, the
blade and jig will be damaged.
To adjust the blade clearance:
1.
disConnECt
tABlE
poWEr!
2.
Make sure the saw blade is perpendicular to
the table and parallel with the miter slot.
3.
Make sure the jig side support is perpen-
dicular to the table (refer to Side Support
adjustment on page 12 for detailed instruc-
tions).
-14-
⁄
" away
1
2
⁄
" away from
1
2
sAW
FroM
4.
loosen the jam nut on the safety stop set
screw, then back the set screw out so that
it will not interfere with adjustments (see
figure 16).
Micro-Adjust lock lever
slide plate
lock lever
safety stop set screw &
Jam nut
figure 16. side support safety stop.
5.
Fully raise the saw blade.
6.
loosen the slide plate and micro-adjust lock
levers, then use the clamp handwheel to
move the clamp screw and shoe out of the
way for the next step (see figure 17).
Clamp shoe
figure 17. Checking for side support parallelism
with the saw blade.
guide Bar
Access hole
slide plate
h7583 tenoning Jig
Advertisement
Table of Contents
