Table of Contents
Advertisement
Blade Clearance
Adjustment
In this procedure you will adjust the work support
plate parallel and
⁄
" away from the edge of the
1
8
saw blade. Then set the positive stop so the work
support plate can be quickly returned to this posi-
tion after cutting various thicknesses.
MAKE SURE the blade clearance is adjusted
correctly! DO NOT adjust the work support
plate any closer than
If the blade contacts the work support plate,
severe injury may occur. If the blade must
be closer than
⁄
" for special circumstances,
1
8
fasten a block of wood through the holes in
the work support plate to prevent the saw
blade from contacting the jig.
Jam Nut
and Positive
Stop
Figure 10. Blade clearance adjustment.
-12-
⁄
" from the saw blade.
1
8
Figure 11. Blade parallelism.
H7583 Tenoning Jig
Advertisement
Table of Contents
