Radio Shack 7-in-One Home Theater Owner's Manual page 50

15-1935.fm Page 50 Thursday, December 31, 1998 11:37 AM
Problem
Problems changing chan-
nels.
The red light blinks when
you press a key but you
receive no response from
your device.
You can turn your audio
component on and off
and control its volume,
but you cannot change
preset channels.
Your satellite receiver
does not respond to the
codes listed in the man-
ual.
The 7-in-One does not
operate Bang & Olufsen
audio equipment.
Need help? Call 1-800-763-9232
50
Solution
If your original remote required
an ENTER keystroke when
changing channels, press the
ENTER key on the 7-in-One
after you enter the channel num-
ber.
Press the appropriate device
key (MAN, TUN, TV, CBL, CD,
VCR, SAT, PLUG 'N POWER)
for the device you are trying to
operate.
Make sure you aim your 7-in-
One at your device and that you
are within 15 feet of the device
before using your remote.
Some audio components might
need both a Tuner/Receiver
code (see Page 29) and an
Audio Amplifier code (see Page
32) to control all the features of
your audio component.
The codes listed in this manual
are set up to operate your satel-
lite receiver on the 1st or 2nd
addresses only. Make sure the
satellite receiver you are setting
up can be operated with an
infrared remote.
Some Bang & Olufsen and other
manufacturers' equipment oper-
ates at frequencies higher than
100 kHz. The 7-in-One will not
operate such devices.