Using The Ir/Rf Command Center - Radio Shack 7-in-One Home Theater Owner's Manual

15-1935.fm Page 46 Thursday, December 31, 1998 11:37 AM
in-One's memory. It does not erase the setup codes you
programmed.
To reset the 7-in-One using the Clear All feature:
1. Hold down . TIMED SEQ appears.
SETUP
2. Press twice. CONFIGURE appears.
MENU
3. Press . THEATER SEL appears.
SELECT
4. Press . CLR ALL appears.
MENU
5. Press . CLR ALL appears.
SELECT
6. Press again. CONFIRM appears.
SELECT
7. Press once more. Your 7-in-One is reset.
SELECT
USING THE IR/RF COMMAND
CENTER
The 7-in-One comes with an IR/RF Command Center
which receives radio frequency (RF) signals from the 7-
in-One and converts them into infrared (IR) signals to
control your components.
Note: The 7-in-One's actual range depends on the con-
struction of the building where it is used, as well as other
factors, such as radio frequency interference. For the
best operation:
• Aim the 7-in-One toward the room where the Com-
mand Center is located.
• Do not position the Command Center near metal
objects (such as heating ducts) that can absorb RF
signals.
• Keep fresh batteries in the 7-in-One. Weak batter-
ies reduce the 7-in-One's range.
Need help? Call 1-800-763-9232
46