Operating Sequence - Rotary Control Oven - Electrolux e:line EOEM61CS User Manual

8 operating sequence – rotary control oven
Operating sequence –
rotary control oven
Select the cooking function
• Turn the function selector in any direction to the desired
cooking function. The oven cavity light will come on.
Select the temperature
• To set the temperature, turn the temperature selector in
a clockwise direction to the desired setting. An indicator
light above the temperature selector will come on.
• A thermostat controls the temperature in your appliance.
When the temperature is reached, the heating source
switches itself off and the indicator light goes out. When
the oven temperature falls below the desired setting,
the heating source switches on and the indicator light
comes on again.
• Once the food is cooked, turn the temperature selector
back in an anti-clockwise direction. Do not force it right
round in a clockwise direction as this will result in
damage to the thermostat.
Note:
• T he desired cooking function must be selected before
the oven will operate.
Temperature estimations
If a recipe calls for Fahrenheit (°F) or no actual
temperatures, use the following table to determine the
temperature (°C).
oven
Low heat
Cool
Very slow
Slow
Moderate heat
Moderately slow
Moderate
Moderately hot
High heat
Hot
Very hot
Extremely hot
electrolux e:line ovens
temperature°C temperature°F
80 175
100-110 210-230
130-140 265-285
150-160 300-320
170-180 340-355
190-200 375-390
200-210 390-410
220-230 430-450
240-250 465-480
tips and information
Pre-heating
For best cooking results you must pre-heat your oven
and grill. Pre-heating your appliance allows it to reach the
required temperature quickly and efficiently as well as cook
your food at the correct temperature for the entire cook time.
1. With 'Rapid Heat' function
This function allows your oven to reach preset temperature
quicker than any other cooking function. Turn the function
selector to 'Rapid Heat', then set the desired temperature,
by rotating your oven temperature selector.
When the indicator light above the temperature selector
goes out, the oven has reached the desired temperature.
Select the oven function you require for cooking and place
the food in the oven.
2. With other oven functions
Set the desired temperature by rotating your oven temperature
selector. When the indicator light goes out the oven has
reached the desired preset temperature, place your food in
the oven, close the door and set the timer if you desire.
3. With 'Grill' function
Pre-heat the grill for at least 3 minutes to obtain best
results. This will help to seal the natural juices of steak,
chops and other meats for a better flavour.
tips and information
Cooling / Vent fan
prevents your kitchen cabinet from overheating and
reduces the condensation inside the oven. It will operate
whenever you are using your oven and blow warm air
across the top of the oven door.
Note:
• If the oven is still hot from cooking, the cooling fan will
keep running to cool the oven down and will switch o
by itself once cool.
Condensation
• E x e c s s condensation may fog the oven door. This may
happen when you are cooking large quantities of food
from a cold start. You can minimise condensation by:
– K e e p n i g h t e a mount of water used whilst cooking to
a minimum.
–
– B k a n i g c u stard in a baking dish that is slightly smaller
than the water container.
– C o o k n i g a c s s r e oles with the lid on.
Note:
• If you are using water in cooking, this will turn to steam
and may condense outside your appliance. This is not
a problem or fault with your oven.