Abit PX5 User Manual page 62

A-6
Installing PS2 Mouse:
cable that comes with the hardware to the connector on the mainboard. Install the
bracket located on the other end of the computer case. When you buy a Mouse, it
has to be a PS/2 Mouse for it to be connected to this port.
Attach the bracket of Parallel Port, Serial Port and PS2 Mouse on the
computer case.
Installing CPU Fan Power
connector:
three-threads CPU Fan power cable to the Fan connector on the mainboard.
Pin number
1
2
3
Adjusting other jumpers:
or are not to be adjusted in normal operation. Adjust them according to the following
recommendations.
CCMOS ¡G Put jumper on pin 1 and pin 2.
BIOS Setup:
steps described above and completed the installation, when you power the computer
on, you will see the following message displayed:
TO ENTER SETUP BEFORE BOOT PRESS CTRL-ALT-ESC OR DEL
KEY
Press immediately Del key to enter BIOS Setup. Select Load Setup Defaults, than
enter CPU Soft Menu to set CPU parameters.
Mouse - Connect the six-threads PS/2 Mouse
Name of the signal or signification
Ground
+12V
Ground
Some jumpers are reserved for future functions
Parameters and CPU settings After you have followed the
FAN1 - There is a specific
orientation. Connect
Appendix A
the