Connection To Modulator Card; Connection To Up-Converter Device - Fujitsu DVB-S User Manual

Chapter 2 Installation and Connection
2.3 2.3

Connection to Modulator Card

This section describes how to connect with the DVB-S/S2 Modulator card.

2.3.1 Connection to Up-Converter Device

When IP-9500 series operates with the encoder mode and also with the DVB-S/S2 mode, the
cable is connected to "RF-OUT" on the DVB-S/S2 modulator card as shown in the figure below.
- In the case of DVB-S/S2 IF band modulator card, please use the BNC cable.
- In the case of DVB-S/S2 L band modulator card, please use the F cable.
For details about connectors and cables, see Section 3.2, "Cable and Connector Details."
NOTE:
For electrical specifications, see Section 3.3, "Function Specifications."
PUSH PUSH
Ｆ/Ｐ ７５［Ohm］Ｃａｂｌｅ
ＢＮＣ/Ｐ ７５［Ohm］Ｃａｂｌｅ
（Ｌ Ｂａｎｄ）
（ＩＦ Ｂａｎｄ）
Up converter
Figure Connection to UpConverter Device
DVB-S/S2 Modulator Card
11