Part Names - Fujitsu DVB-S User Manual

1.3
1.3

Part Names

This section gives the name and describes the function of individual parts of DVB-S/S2 optional card.
The figure below shows the layout of parts on the outside of the device, and the table below lists the
name and describes the function of individual parts.
Part names
No. Name (as indicated)
Screws
(1)
Levers
(2)
Power LED lamp
(3)
(PWR)
Alarm LED lamp
(4)
(ALM)
Radio frequency output connector
(5)
(RF-OUT)
DVB-ASI output connector
(6)
(ASI-OUT)
Figure IP-9500 series Rear Panel
Screws for securing the DVB-S/S2 modulator card in an
optional-card slot of this device in the IP-9500 series
Levers used to insert the DVB-S/S2 modulator card into or remove
it from optional-card slot of this device in the IP-9500 series
Lamp that goes on when the power to the card is turned on
Lamp that goes on if the card has an error
Terminal for radio frequency output. Its unbalanced output is 75Ω.
The output radio frequency and connector are either the IF-band
frequency/BNC connector or L-band frequency/F connector,
depending on the type of optional card that you purchased.
For details about the cable connection, see Section 2.3.1,
"Connection to Up-Converter Device."
For details about the specifications, see "Radio frequency output" in
Section 3.3.4, "Equipment Specifications."
Terminal for DVB-ASI output. It is a BNC connector, and its
unbalanced output is 75Ω.
For details about the cable connection, see Section 2.3.2,
"Connection to DVB-ASI Input Device."
For details about the specifications, see "DVB-ASI output x 1" in
Section 3.3.4, "Equipment Specifications."
5
Chapter1 Preparations
Description
DVB-S/S2 Modulator Card