Abit BE7-G User Manual page 63

BIOS Setup 3-21
NOTE: This feature needs a specific network interface (optional). Also your ATX power supply +5V
standby power must be at least 720mA compatible.
WakeUp by Ring:
Two options are available: Enabled and Disabled. Default setting is Disabled. If you connect an external
modem to the onboard serial port, the system will be turned on when a telephone ring-up occurs.
WakeUp by Alarm:
Two options are available: Enabled and Disabled. Default setting is Disabled. The RTC alarm can turn on
the system. You can set Date (of month) and Time (hour, minute, and second) when you set this item to
Enabled.
POWER ON Function:
This item allows you to select by which way you want your system to power on. The options are:
Password Hot Key Mouse Left Mouse Right Any Key Button Only Keyboard 98. The
default setting is Button Only.
NOTE: The mouse wake up function can only be used with the PS/2 mouse, not with a mouse that uses
the COM port and USB connection. Mouse Left (Mouse Right) means you need to double click the mouse
left (right) button, for the computer to power on. You also need to note the compatibility issue with your
PS/2 mouse. Some PS/2 mice cannot wake up the system because of compatibility problems. Also, if the
specs of your keyboard are too old, it may fail to power on.
KB Power ON Password: This option allows you to set a password required in order to Power ON your
computer. You will be asked to enter your password and then to confirm it. Do not forget your password.
Should you forget your password, you will have to open your computer case, clear the CMOS and reset
all parameters again in order to be able to utilize this function.
Hot Key Power ON: There are twelve options are available, Ctrl-F1 to Ctrl-F12. You can select this item
and using the <Ctrl> plus the one of each function key (F1 to F12) to power on the computer. The default
setting is Ctrl-F1.
Restore On AC Power Loss:
This item allows you to select the system action after a power failure. The options are: Power Off
Power On Last State. The default setting is Power Off.
User's Manual