Abit BE7-G User Manual page 58

3-16 Chapter 3
Init Display First:
Two options are available: PCI Slot and AGP. The default setting is PCI Slot. When you install an
additional display card, you can choose either a PCI display card or an AGP display card to activate the
display boot-up screen.
Onboard PCI Device(s):
Press <Enter> key to enter the Onboard PCI Device(s) menu.
LAN Controller:
This option enables or disables the LAN controller. The default setting is Enabled.
LAN Boot ROM:
This option enables or disables the Boot ROM on LAN controller. The default setting is Enabled.
ATA133RAID IDE Controller (For BE7-RAID):
This item selects the onboard ATA133RAID controller. When set to [Enabled], two additional channels
will be provided for adding high performance devices to system.
Serial ATA Controller (For BE7-G and BE7-S):
This item selects the onboard Serial ATA controller. When set to [Enabled], two additional channels will
be provided for adding high performance devices to system.
Onboard FDD Controller:
Two options are available: Enabled and Disabled. The default setting is Enabled. You can enable or
disable the onboard FDD controller.
Onboard Serial Port 1:
This is used to specify the I/O address and IRQ of Serial Port 1. Six options are available: Disabled
3F8/IRQ4 2F8/IRQ3 3E8/IRQ4 2E8/IRQ3 AUTO. The default setting is 3F8/IRQ4.
Onboard Serial Port 2:
This is used to specify the I/O address and IRQ of Serial Port 2. Six options are available: Disabled
BE7 Series