Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Electrolux EFP 662
Summary of Contents for Electrolux EFP 662
-
Page 1: Installation Instructions
Cooker hood OPERATING AND INSTALLATION INSTRUCTIONS EFP 662 375 1514 00 / 02.05... - Page 2 Dear Customer Please read these operating instructions carefully. Pay These operating instructions contain information on particular attention to the section entitled ”Safety infor- elimination of any faults occurring. Refer to section mation”. entitled ”What to do if ...” Keep these operating instructions for later reference If this information is not sufficient, there are two con- and pass them on to any subsequent owner of the unit.
-
Page 3: Table Of Contents
Content Safety information ............. . . Electrical safety . -
Page 4: Safety Information
Safety information The safety of this unit complies with recognised techni- Safety during use cal regulations and the safety instructions effective. We must, however, draw your attention to the following The cooker hood should only be used for ventilating safety information. the cooking area. -
Page 5: Disposal
Disposal Packaging material The packaging materials are environmentally friendly and can be recycled. The plastic com- ponents are identified by markings, e.g. >PE<, >PS<, etc. Please dispose of the packaging materials in the appropriate container at your local waste disposal facilities. Old appliance The symbol on the product or on its packa-... -
Page 6: Your Cooker Hood
Your cooker hood View of unit Extension Fan slide switch Lamp slide switch Lamp Metal filter Name-plate Special accessories Stop springs Detent springs Carbon filter The cooker hood can be fitted for two different modes of operation: Exhaust version The fumes produced over the cooker are cleaned in the fat filter and taken outside via an exhaust pipe. -
Page 7: Operation Of Cooker Hood
Operation of cooker hood Switching on The fan is switched on automatically to the preselected position of the slide switch (2) by pulling out the exten- sion (1), unless the switch is set fully left at position 0. The air flow can be regulated with slide switch (2). Position Types of cooking switched off... -
Page 8: Cleaning And Servicing
Cleaning and servicing Caution! Do not use sharp cleaning agents, brushes, sponges which cause scratching or abrasive sand. External cleaning Clean the external parts with a cloth moistened with a mild detergent solution. Cleaning the metal filter Warning! There is danger of fire if these cleaning in- structions are not observed! Withdrawing metal filter 1. -
Page 9: Cleaning The Glass Extension
Cleaning the glass ex− tension Removing the glass extension 1. Pull out glass extension (1) to stop. Detail A 2. Press up the springs (7) fixed to the extension rails (6) with the index fingers and carefully pull out the glass extension (1). -
Page 10: Replacing The Lamps
Changing the carbon Caution! The carbon of the filter should be changed at least once annually. 3. Unscrew carbon filter. 4. Remove used carbon. 5. Fill with fresh carbon (Replacement carbon no. 009 424 024-29/8). 6. Screw up carbon filter. Inserting carbon filter 7. -
Page 11: What To Do If
What to do if ... Fault Cause Remedy Check that fuse is ok No power supply Check that mains cable is plug- No hood function ged in correctly. Fan does not run Fan does not run Extension not pulled out Pull out extension No light Bulb defective... -
Page 12: Installation Instructions
Installation instructions Safety information Warning! The minimum safety spacing “D” between cooking surface and hood is 500 mm for electrical cookers and 700 mm for gas max. 140 cookers. The unit must be disconnected from the power supply for servicing purposes. Withdraw the mains plug. -
Page 13: Fitting For Circulating Air
Fitting for circulating Ventilation grille min. 200 cm If no exhaust pipe can be fitted for structural reasons, max. 140 the cooker hood can be provided with an additional activated carbon filter to retain bacteria and odours. The cleaned air is then returned to the cooking area. Caution! The damming flap must be removed for circulating air operation, since otherwise the cooker hood does not operate. -
Page 14: Fitting Instructions
Fitting instructions ø8x16 ø8x26 Caution! Before the cooker hood is fitted, the filter and glass extension must be removed (see section ”Cleaning and servicing”). Caution! Screws and studs are intended for a wall thickness of min. 16 mm. Caution! The hood must be secured to the base with 6 screws and the specified studs (I, ø4x30 ø4x40... - Page 15 4. Raise cooker hood up to stud and insert in guide/ mount (as arrow). 5. Provide screw connection for fixing stud (II) im- mediately without fail after engaging. Caution! Fixing studs as shown in detail A (countersinking to screw head). Following lateral fixing of the cooker hood, the upper fixing must also be performed.
-
Page 16: Fitting The Carbon Filter
Fitting the carbon filter Applies only to circulating air operation. Caution! All four springs must be used to en- sure effective function. 1. Pull out extension (1). 2. Remove metal filter (5). 3. Insert stop springs (8) at rear right and left on longi- tudinal side of outlet hole between sheet metal and plastic case up to stop. -
Page 17: Technical Data
Technical data External dimensions Total height 413 mm Visible unit height 49 mm Width 598 mm Depth 320 mm Depth with extension open 520 mm Minimum spacing from cooking area Electrical cooker 500 mm Gas cooker 700 mm Connection voltage 230 V ~ 50 Hz Power consumption Total consumption 240 W... -
Page 18: Service
• Note the following data specified on the name- Prod-nr: ELECTROLUX 230 V ~50Hz Serie plate of your unit: EFP 662 EZ 13 Serial number Model designation Prod. number Model designation • Please always state these data for: Requesting customer service... -
Page 19: Guarantee Conditions
Guarantee conditions Standard guarantee conditions We, Electrolux, undertake that if within 12 months of the date of the purchase this Electrolux appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: •... - Page 20 by Electrolux...