Fluke 1730/BASIC User Manual page 44

1730
Users Manual
8. With all of the connections done, check that the
voltages for phases A/L1, B/L2, and C/L3 are as
expected.
9. Read the current measurements for phases A/L1,
B/L2, and C/L3.
10. Push Verify Connection to check and correct the
phase rotation, phase mapping, and polarity of current
probes.
11. Push Live-Trend to display a chart of the last
7 minutes.
In most installations a clockwise rotation is used.
12. Push  to determine the power values, especially
active power and power factor.
13. Push Live-Trend to display a chart of the last
7 minutes.
14. Push  for 3 seconds to take a snapshot of the
measurements.
15. Push  and change the default configuration with
Edit Setup.
Typical setup:
- 1 week duration
- 1 minute for average calculation interval
- 15 minutes for demand interval
16. Push Start Logging.
You can review the live data with  or . Return
to the active logging session with . Once the
36
Shop for Fluke products online at:
logging session is completed it is accessible in
Memory/Settings - Logging Sessions.
17. Review the logged data using the softkeys V, A, Hz, +,
Power, and Energy. See page 28 for more
information.
18. To transfer and analyze the data using the PC
software, attach the USB flash drive to the Logger and
copy the logging session and screenshot.
You can also use the USB cable to transfer the
measurement data but the transfer of the
screenshot via cable is not supported.
To analyze the data using the PC software:
1. Attach the USB flash drive to a PC with Energy
Analyze installed.
2. In the software, click Download and copy the logging
session from the USB flash drive.
3. Open the downloaded session and view the measured
data.
4. Go to the Project Manager tab and click Add Image to
add the screenshot.
For more information about how to use the Energy
Analyze, see the online help for the software.
MyFlukeStore
www.
Note
1.877.766.5412
.com