What To Do If - Zanussi ZOD35702BK User Manual

A
3. Close the oven door until the first position
(angle approx. 45°).
45°
4. Hold of the oven door with one hand on
each side and pull it away from the oven at
an upwards angle.
Put the oven door with the outer side
down on a soft and level surface to pre-
vent scratches.
5. Now you can remove the inner glass pan-
els and clean them.
To install the door follow the procedure in
reverse.
The oven door has 2, 3 or 4 panels of
glass (depends on the model)
Removing and cleaning the door glasses
1. Hold the door trim (B) on the top edge of
the door at the two sides and push inwards
to release the clip seal.
B

What to do if...

18
2. Pull the door trim to the front to remove it.
A
3. Hold the door glass panels on their top
edge one by one and pull them upwards
out of the guide
4. Clean the door glass panels.
To install panels follow the procedure in re-
verse. Insert the smaller panel first, then the
larger.
Oven lamp
Warning! There is a danger of electrical
shock!
Before you change the oven lamp:
• Switch off the oven.
• Remove the fuses in the fuse box or switch
off the circuit breaker.
Put a cloth on the bottom of the oven for
protection of the oven light and glass cov-
er.
Replacing the oven lamp
1. You can find the lamp glass cover at the
back of the cavity.
Turn the lamp glass cover counterclock-
wise to remove it.
2. Clean the glass cover.
3. Replace the oven lamp with applicable
300°C heat-resistant oven lamp.
Important! Use the same oven lamp type.
4. Install the glass cover.
www.zanussi.com