Specifications - 44A Four - Westerbeke 8.0KW-60Hz Service Manual

SPECIFICATIONS 44A FOUR ENGINE
SPECIFICATIONS
Engine Type
Displacement
Aspiration
Combustion Chamber
Bore & Stroke
Firing Order
Direction of Rotation
Compression Ratio
Dimensions - inches (mm)
Engine Only
Weight
Fuel Consumption
inclination
Diesel, four-cycle, four-cylinder, fresh water-
cooled, vertical in-line overhead valve
mechanism ..
107.3 cubic inches (1.758 liter)
Naturally aspirated.
Swirl type.
3.07 x 3.62 inches (78 x 92 mm)
1-3-4-2
Clockwise, when viewed from the
front
22:1
Height: 18.6 inches (472.4 mm)
Width: 23.0 inches ( 584.2 mm)
Length:25.6 inches (914.4 mm)
3311bs (150 kgs) without t"'nsmission.
2.5 glhr (9.7ltrlhr) at 3600 rpm
Continuous 15<>
Temporary 25' (not to exceed 30 min.)
TUNE-UP SPECIFICATIONS
Compression Pressure
Minimum
Valve liming
Spilled liming (Static)
Valve Seat Angle
Engine Speed
Valve Seat Angle
Injector Pressure
Engine Timing
427 psi (30 kg/cm') at 280 rpm
384 psi (27 kg/cm')
Intake Opens
Irtake Closes
17' (spill)
45'
3600 rpm
Intake 45'
Exhaust 30'
1991 + 71 - 0 psi (140 + 5 - 0 kgflcm').
1JO BTOC
General
Fuel
Fuel Injection Pump
Fuel Injection Timing
Nozzle
Fuel Filter
Air cleaner
Air Flow
(engine combustion)
Fuel Lift Pump
Starting Battery
Battery Capacity
DC Charging Altemator
Starting Aid
Starter
General
Operating Temperature
Fresh Water Pump
Raw Water Pump
System Capacity
(Fresh Water)
General
Oil Filter
Sump Capacity
(not including fliter)
Operating Oil Pressure
(engine hot)
Oil Grade
Engines & Generators
58
FUEL SYSTEM
Open flow. self priming.
No.2 diesel oil (cetane rating of 45 or higher),
In-line plunger type (BOSCH).
0' TOC (Top Dead Center).
Throttle type.
Spin-on replaceable (PN#024363) ..
Replaceable paper filter cartridge.
140 cfm (3.9 cmm) at 3600 rpm.
12 volt DC lift capacity of 5' (1.5 mm) solid state
12 Volt,
H
negative ground
400 - 600 Cold Cranking Amps (CCA)
51 Amp rated, belt-driven
Glow plugs, sheathed type
12 Volt, reduction gear
COOLING SYSTEM
Fresh water-cooled block, thermostatically-
controlled with heat exchanger.
170-190 0 F (77 -88' C)
Centrifugal type, metal impeller, belt-driven.
Positive displacement, rubber impeller,
belt-driven.
2.65 US qts (2.5 iiters)
Pressure fed system.
Full flow, paper element. spin-on type,
4.5 U.S. qts (4.3 liters)
50 - 60 psi (3.5 - 4.2 kg/cm')
API Specification CF or CG-4.