Table of Contents
Advertisement
5. Operation of projector
5.2. Confirmation of projector status
The status of the projector is displayed on the projector list on the main screen.
Item
Check
No.
Projector Name
MAC Address
IP Address
Power
*1
Input Source
AV Mute
Lamp 1/2 Time (Low)
Group Name
*1
HDMI and DVI-D are displayed with DIGITAL 1 or DIGITAL 2 by a connected projector.
• The projector status is re-obtained (refreshed) automatically and periodically, but the present status can also be
obtained by the user's instruction. When clicking [Refresh Status] of the tool bar on the main screen, Power, Input
Source, AV Mute, and Lamp 1/2 Time (Low) status of each projector is re-obtained.
• The status of Input Source and AV Mute will not be obtained under the following conditions:
- when the projector is powered off
- during warm-up or cool-down.
• When clicking the status tag of the projector list (except the MAC address), the list can be rearranged (sorted).
The list can be rearranged in reversed order by pressing one more time.
• When clicking [Select All] of the tool bar, all projectors in the projector list become selected/non selected state.
• If any abnormal state of the projector is detected by acquiring the projector status, an error message will be
displayed on the error message display column at the lower part of the screen.
<Note>
• The default cycle of the automatic re-acquisition is 10 minutes. To change this cycle, see "3.1. System settings."
• When multiple projectors are connected, it may take time to acquire the status. During acquiring the status, the
status bar at the lower part of the main screen becomes "Getting status...", and it becomes "Done" when the
acquisition has been completed.
Description
Theft detector setting (ON/OFF)
Projector list registration number
Projector name set in the application
MAC address of the projector
IP address of the projector
Power supply status of the projector (ON/OFF)
Input signal of the projector (COMPUTER 1/COMPUTER 2/VIDEO/S-VIDEO/HDMI
(HDMI1/HDMI2)/DVI-D/SDI/USB Viewer/PC Less Presentation/USB Display/LAN
Display/COMPONENT)
Mute status of the projector (ON/OFF)
Lamp illuminating time (HHHH:MM or HHHHH:MM)
In the case of the projector equipped with two lamps, illuminating time for the lamp 1
is displayed in the left side and illuminating time for the lamp 2 is displayed in the right
side. For the lamp-free projectors, light source usage time is displayed instead of
lamp times. In this case, the time is not Low-mode equivalent time but actual usage
time.
The belonging group of projector
EN-15
Advertisement
Table of Contents
