Abit BP6 User Manual page 23

Installing the Motherboard
PN1 (Pin 1-2): Hardware Reset Switch Header
PN1 (Pin 4-5-6-7): Speaker Header
PN1 (Pin 9-10): Suspend LED Header
PN2 (Pin 1-2-3-4-5): Power LED and Keylock Switch Headers
install them with the wrong direction, the power LED light will not illuminate correctly.
Note: Watch the power LED pin position and orientation.
Attach the cable from the case's front panel
Reset switch to this header. Press and hold
the reset button for at least one second to
reset the system.
Attach the cable from the system speaker to
this header.
Insert the two-threaded suspend LED cable
into pin 9 and pin 10. If you install it in the
wrong direction, the LED light will not
illuminate correctly.
There is a specific orientation for pins 1
through 3. Insert the three-threaded power
LED cable to pins 1~3, and the two-threaded
keylock cable into pin 4 and pin 5. Check to
make sure the correct pins go to the correct
connectors on the motherboard. If you
2-11
User's Manual