Abit BP6 User Manual page 24

2-12
PN2 (Pin 6-7): HDD LED Header
Note: Watch the HDD LED pin position and the orientation.
PN1 (Pin 8-9): Power on Switch Header
PN2 (Pin 10-11): Hardware Suspend Switch (SMI Switch) Header
Note: If you enable the ACPI function in the BIOS setup, this function will not work.
Note: Watch the Suspend LED pin position and the orientation.
For the PN1 and PN2 pin's count-name list, please refer to table 2-2.
BP6
Attach the cable from the case's front panel
HDD LED to this header. If you install it in
the wrong direction, the LED light will not
illuminate correctly.
Attach the cable from the case's front panel
power switch to this header.
Attach the cable from the case's front panel
suspend switch (if there is one) to this
header. Use this switch to enable/disable the
power management function by hardware.
Chapter2