Abit BP6 User Manual page 21

Installing the Motherboard
WOL: Wake on LAN Header
SMBCON: System Management Bus Connector
Note: Watch the pin position and the orientation
CCMOS: CMOS Discharge Jumper
If you have a Network adapter that supports
this feature, then you can connect the
specific cable from the network adapter to
this header. This feature lets you wake up
your computer via remote control through a
local area network. You may need a specific
utility to control the wake up event, like
®
using the Intel LDCM
similar utilities.
Note: Watch the pin position and the
orientation
This connector is reserved for system
management bus (SMBus). The SMBus is a
specific implementation of an I
a multi-master bus, which means that
multiple chips can be connected to the same
bus and each one can act as a master by
initiating a data transfer. If more than one
master simultaneously tries to control the
bus, an arbitration procedure decides which
master gets priority.
Jumper CCMOS discharge CMOS memory.
When you install the motherboard, make
sure this jumper is set for normal operation
(pin 1 and 2 shorted). See figure 2-8.
2-9
®
utility or other
2 2
C bus. I C is
User's Manual