Yamaha DVR-S200 Owner's Manual page 79

Input signal information
I
(Format)
Shows the input signal format. When the digital input
cannot be recognized, the mode is set to analog.
Input Signal
Analog Audio
PCM Audio
Dolby Digital Audio
DTS Audio
Other Digital Signals
I
(Audio Channels)
Shows the number of audio channels an input signal
contains (only when Dolby Digital or DTS is input).
For example, "in: 3/2/LFE" indicates 3 Front Channels,
2 Surround Channels and LFE.
"1+1" indicates Main + Sub in bilingual broadcasts or
other 2 channel audio, and MLT indicates 3-channel or
more multi-channel audio.
I
fs
Shows the frequency sampling of an input signal (only
when digital signal is input). If the sampling frequency
cannot be measured, "unknown" appears.
I
rate (bit rate)
Shows the amount of data an input signal contains per
second (only Dolby Digital and DTS). If the bit rate
cannot be measured, "unknown" appears.
I
flg (flag)
Shows a recognition signal (flag), in an input signal and
initiates an action (only Dolby Digital and DTS). If the
flag cannot be recognized, "None" appears.
Format Display
Analog
PCM
Dolby DGTL
DTS
Unknwn DGTL
Note on digital signals that exceed 48 kHz
CinemaStation's digital input jack can input a sampling
frequency up to 96 kHz. For details read the owner's
manual of the device connected to the digital input jack.
Keep in mind the points below when inputting a digital
signal that exceeds 48 kHz.
• DSP Programs are not selectable. You can only listen to
normal 2-channel stereo from the Front Speakers.
• During playback, you cannot adjust the volume level of
Center and Surround L/R Speakers.
• Depending on the "* Speaker Set" setting in the SET
MENU, the Subwoofer may output sound.
Types of Input Signals
77